Heya - In wonder if someone can help me out here.<br /><br />I've got a working TARBS (yes, the stock standard ones) BOX. I've been reading that with a FTA digital receiver I can get the FTA channels that were under TARBS before.. here's how I went:<br /><br />1. powered up HUMAX (VA-ACE) unit, operationally looks AOK.<br /><br />2. removed sat cable from working TARBS box (note, dish already re-aligned) and insert into HUMAX box 3. configure following parameters on HUMAX box (identical from working TARBS box).<br /> - LNB 11300<br /> - Transponder Freq 12640<br /> - Symbol Table 22500<br /> - 22K Tone off<br /> - Polariz: H<br /> - FEC: Auto Detect<br /><br />On HUMAX box, I am getting a SIGNAL LEVEL of 85 (on old TARBS-box was about 70). <br /><br />On HUMAX box, I am getting a SIG QUALITY of ZERO (0) however.... This was about 57 on the working box.<br /><br />Here-in lies my problem.<br /><br />I attempted a clean sweep scan but still nothing.<br /><br />My objective was to get 2 units in the house working, but am tripping at getting the new one working. <br /><br />Can anyone advise me where I am going wrong.<br /><br />Thanks In Advance!